Measured, or estimated?
Your watch measures a few things directly: time, satellite positions, the movement of the watch and, through the light sensor on the back, changes in blood flow under the skin. Everything else is worked out from those with formulas, and the further a number is from the raw data, the more it’s an estimate.
| Metric | What it comes from | How much to trust it |
|---|---|---|
| Time | The clock | Exact |
| Distance, pace | GPS positions | Good in the open, worse in cities, forests and on tracks |
| Heart rate | Wrist light sensor, or a chest strap | Chest strap closer to the truth |
| Cadence | The watch’s motion sensor | Usually close |
| Contact time, bounce | Motion sensor, or a sensor on a strap or shoe | Estimates; best for your own trends |
| VO2max | A formula using pace and heart rate | Rough for one person |
| Training load, recovery, readiness | Formulas the makers mostly don’t publish | Unknown; use as a prompt |
Pace and distance
GPS works out where you are from satellite signals every second or so. Under trees, between tall buildings or on a track’s tight bends, the signal bounces and the points wobble, so distance and pace can be off. Instant pace jumps around for the same reason; an average over a lap or a kilometre is steadier.
On a treadmill, the watch guesses pace from your arm swing, which is less reliable. See where to run.
Heart rate
In 50 adults on a treadmill, bike and elliptical, a chest-strap monitor agreed most closely with an ECG. Wrist-worn optical monitors were less accurate, most of all on the ellipticalE19.
Two more things to know:
- Drift. On a long steady run, heart rate slowly climbs even at the same pace, more so in heat or when you’re low on fluidE18. A rising heart rate late in a long run isn’t necessarily a sign you’re running too hard.
- Zones depend on your maximum. Watches often set zones from an age formula. A large analysis gave maximal heart rate as about 208 − 0.7 × age, but with a typical error of around 10 beats a minute for one personE15. See heart-rate zones for better ways to set them.
Cadence, contact time and bounce
Cadence is your steps per minute. A higher step rate at the same speed goes with less vertical bounce and lower ground forcesH8, which is why some runners use it as a cue. See cadence and step length.
Ground contact time and vertical oscillation (bounce) are estimated from motion sensors. They change with speed, so compare like with like: the same pace, on the same kind of run. The running stride lab shows how they fit together in a simple model of a typical runnerR1.
VO2max estimates
Watches estimate VO2max from your pace and heart rate. Pooling 14 validation studies, wearables that estimate it from resting data overestimated it by about 2 ml/kg/min on average, with wide errors for individuals. Estimates made from exercise data were right on average, but one person’s reading could still be off by roughly 10 ml/kg/min either wayT7.
So your watch’s VO2max is best used as a trend: if it creeps up over months of training, that’s a good sign. Don’t compare your number with a friend’s, and don’t worry about a small drop after a hot week or a hilly run. See VO2max.
Training load, recovery and readiness
Training load, recovery time, readiness, “training status” and similar scores combine your heart rate, pace, sleep and sometimes heart-rate variability with formulas that each maker designs. Most of these formulas aren’t published, so it’s hard to know how well they work.
Use them as a prompt to check in with yourself, not a verdict. If the watch says you’re recovered but your legs feel heavy and you slept badly, trust your body. If it says you need three days’ rest after an easy run, it’s probably wrong.