Abhijeet I.Jezero Base · Running Atlas
Preview

Shoe science: foam, drop, plates

A running shoe is a stack of layers. Thick, springy foam and a stiff plate can make racing a little cheaper in energy, while drop and cushioning have smaller and less certain effects on injury. For everyday running, comfort is still the best guide.

3D labAbout 8 min read6 claims gradedUpdated 12 November 2026

In short

  • Stack is the height of the sole; drop is the heel stack minus the forefoot stack.
  • A plated shoe with a new foam cut the energy cost of running by about 4% in one lab study of fast runners.
  • Drop didn't change overall injury risk in a large trial. For choosing, comfort is still the best guide.
3D lab

Shoe cut-away

ShoeEveryday trainer10 mm drop, no plate
Start from
Options
View

What a shoe is made of

Cut a running shoe in half from heel to toe, as the lab above does, and you find a few layers:

  • The upper, the fabric that holds your foot.
  • The insole, a thin removable layer under your foot.
  • The midsole, the thick foam that does most of the work.
  • A plate, in some shoes: a thin, stiff sheet inside the foam, often carbon fibre.
  • The outsole, the rubber that touches the ground.

Two numbers describe the sole. Stack is how thick it is under the heel or under the forefoot. Drop is the difference: heel stack minus forefoot stack. A shoe with 34 mm at the heel and 24 mm at the forefoot has a 10 mm drop. Try the presets in the lab to see how these change the shape.

Foam

The midsole foam squashes as you land and springs back as you push off. Foams differ in how soft they are, how much of the energy they give back, and how heavy they are. A light foam lets a shoe have a thick sole without adding much weight.

Press the shoe in the lab to see the foam squash under the heel and the forefoot. Switch off “Soft foam” to see a firmer one. The squash is an illustration, not a measurementH23.

Plates and the “4%” shoe

In 2018, a lab study tested 18 high-calibre runners in a prototype racing shoe with a curved carbon plate and a new foam. Against two established racing shoes, it lowered the energy cost of running by about 4% on average, and it lowered it in every one of the 18H18.

Researchers are still working out how much of that saving comes from the foam, the plate and the shoe’s shape. The study tested fast runners in a lab, so how much it helps slower runners is less clear. Since then, many racing shoes have used a similar mix of thick foam and a stiff plate. For what a few per cent of energy means for speed, see running economy.

Racing rules

To stop shoes growing ever thicker, World Athletics rules limit the sole of a road racing shoe to 40 mm and allow no more than one rigid plate inside itH22. The lab tells you when your shoe goes over that.

Drop and injury

Many runners wonder whether a lower drop is better. In a trial of 553 leisure-time runners given shoes with a 10, 6 or 0 mm drop and followed for 6 months, overall injury risk didn’t differ by drop. Split by how much they ran, low-drop shoes went with fewer injuries in occasional runners and more in regular runners, but this was an exploratory look and needs confirmingH19.

Cushioning and injury

In a trial of 848 recreational runners given a softer or a harder version of the same shoe, the harder shoe went with a higher injury risk. Split by body mass, the difference showed only in the lighter runnersH20. That’s one trial, and it compared two versions of one shoe, so it doesn’t tell you which soft shoe to buy.

Using more than one pair

In 264 recreational runners followed for 22 weeks, those who used more than one pair of running shoes in turn had a lower injury riskH21. It’s a link, not proof: runners who rotate shoes may differ in other ways.

Choosing a shoe

The evidence for matching shoes to your feet hasn’t held up:

  • Runners whose feet roll inwards (pronate) didn’t have more injuries in a neutral shoeS11.
  • Assigning shoes by arch height didn’t reduce injuriesS12.
  • A review proposed a simple “comfort filter”: try several shoes and pick the one that feels most comfortableS10.

For fitting tips and when to replace shoes, see shoes and kit.

Evidence ledger

Every claim on this page, its source and how well it has been checked.

IDClaimSourceGrade
H18In 18 high-calibre runners, a prototype racing shoe with a curved carbon plate and a new foam lowered the energy cost of running by about 4% on average against two established racing shoes, and lowered it in all 18.Hoogkamer et al. 2018, Sports Med 48:1009-1019Not yet checked
H19In 553 leisure-time runners given shoes with a 10, 6 or 0 mm drop and followed for 6 months, overall injury risk did not differ by drop. In an exploratory split, low-drop shoes went with fewer injuries in occasional runners and more in regular runners.Malisoux et al. 2016, Am J Sports Med 44:2933-2940Not yet checked
H20In 848 recreational runners given a softer or a harder version of the same shoe, the harder shoe went with a higher injury risk. Split by body mass, the difference showed only in the lighter runners.Malisoux et al. 2020, Am J Sports Med 48:473-480Not yet checked
H21In 264 recreational runners followed for 22 weeks, those who used more than one pair of running shoes in turn had a lower injury risk (hazard ratio 0.61). A link, not proof.Malisoux et al. 2015, Scand J Med Sci Sports 25:110-115Not yet checked
H22For road races, World Athletics rules limit the sole of a shoe to 40 mm thick and allow no more than one rigid plate inside it.World Athletics Technical Rules, Rule 5 (athletic shoes)Not yet checked
H23The Shoe cut-away is a generic shoe built for the lab, not any brand or model. Its foam squash is an illustration, not a measurement.IllustrationModel

General information, not medical advice.